Cable length: 0.7m.
For the connection between QnAS/AnSCPU/ motion controller A7GT-CNB (A Series) and CPU.
Applicable models: GT16, GT15, GT11. Function: the core function of the condensed display.
Picture size: 3.8 inches.
Resolution: 320 * 128 dot.
Display: TFT monochrome.
Panel color: black GT1585V-STBD.
Power type: DC24V.
Communicaation interface: RS-232 * 2.
Small body equipped with ethernet!
Compared with the past, the upgrade of 320 x 128dot 4 x high resolution lcd.
HD LCD screen GT1585V-STBD.
Equipped with TFT monochrome 32 gray level of high resolution liquid crystal, compact body design and display the effect is clear.
1, SD memory card module with the interface.
Can be installed to buy the SD memory card module, save the alarm and log data.
2, USB interface: device USB (Mini-B USB)
Can connect to the computer to transfer data GT1585V-STBD.
3, RS-422/485 interface.
Can be connected to a variety of FA machines, bar code reader.
4, Ethernet interface.
Up to 2 different manufacturers can be connected to the FA machine.
Backlight color variety, equipment status at a glance MITSUBISHI GT1585V-STBD.
The use of direct 5 color backlight, according to the production of equipment, respectively, the use of backlight color / flicker.
In addition, the control of the backlight can be carried out by connecting the programmable controller. (picture color switching, ON/OFF/ flashing backlight) MITSUBISHI GT1585V-STBD.
A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600) MITSUBISHI GT1585V-STBD.
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper iinstallation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1585V-STBD.