LK Automation Limited LK Automation Limited
Information sort OMRON | MITSUBISHI | Proface | Mennekes | Yaskawa
Home >> Supply
GT1585-STBD MITSUBISHI 121 Inch Touch Screen MITSUBISHI GT1585-STBD


Cable length: 3m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 GT1585-STBD. Prrotective film for 8.4 inch screen.
Transparent, 5.
Applicable model: GT16.
A series of high performance models that are widely used in network or single machine work environments GT1585-STBD.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black GT1585-STBD.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit MITSUBISHI GT1585-STBD.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system MITSUBISHI GT1585-STBD.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI GT1585-STBD. Bus cables used for GOT1000 to replace the ferrite cores used in the existing GOT-A900 bus cables.
Applicable models: GT16, GT15, GT11, GT27, GT25. Cable length: 3m.
Connection between serial communication unit and GOT. Connection between a computer link unit and a GOT.
For the connection between AJ65BT-R2N and GOT (only GT09-C30R2-9P).
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. 48MB extended meemory GT1585-STBD.
Applicable model: GT15. Cable length: 30.6m.
Long distance connection between CPU (A Series) and GOT for QnAS/AnSCPU/ motion controller.
Long distance connection between A7GT-CNB and GOT.
Applicable models: GT16, GT15, GT11.

Related supply information