Power: 15kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed FR-A740-5.5K-CHT PDF. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FR-A740-5.5K-CHT
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used FR-A740-5.5K-CHT PDF. But please pay attention to the allowwable brake use rate FR-A740-5.5K-CHT Manual.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Max input / output points: 48 points FR-A740-5.5K-CHT PDF.
Supply voltage: 100 - 240VAC.
Input points: 24 points.
Output points: 24 points.
Output type: Transistor (sinktype).
Power consumption: 40W.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x86.
Faster and more efficient. Support high speed control and network communication, and have the function of data recording MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
High speed, large capacity, multi-function high-end machine.
FX3U supports high speed processing, CC-Link communication, network communication, analog control and advanced positioning system.
Connected to the CC-Link, including the remote I/O, the maximum input and output control points up to 384 points,
Can correspond to a variety of field needs, the use of its scalability and flexibility to expand the scope of application of the control system MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
Third generation high function micro programmable controller FR-A740-5.5K-CHT PLC FUNCTION PROGRAMMING MANUAL.
High speed, high efficiency, high performance, large capacity, and new features MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
Built in high speed processing and ppositioning FR-A740-5.5K-CHT Manual.
Control points: maximum 256 points.
Use CC-Link remote I/O for 384 points. Can be isolated to obtain DC24/48/100V, AC100/200V input signal.