Length: 3m.
Specification: D-sub 25 pin (male), D-sub 25 pin (male). Series Name: hand held F940GOT (RH type).
System screen display language: english FR-A740-30K-CHT PDF.
Display: 5.7 inches, with a high degree of operational reliability of the handheld GOT.
Display color: 8 color.
Display device: LCD STN.
Resolution: 320 * 240.
Installation type: panel mounting.
The built-in communication port: RS-232C (1ch) FR-A740-30K-CHT
Power supply voltage: DC24V.
GOT-F900 series can be easily applied to a variety of different applications.
3 built-in communication channels.
Screen area.
Through the split screen configuration, you can reduce the operating time FR-A740-30K-CHT PDF.
The image can be divided into two or three parts to display.
According to the user''s application example, the menu screen or the operation of the button sometimes on the screen will often be used to.
As a result, it is very time-consuming and inefficient to make a similar picture every time FR-A740-30K-CHT PDF. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 18.5kw.
SLD converter rated current: 38.0A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor.
The excitation currrent is always adjusted to the best state, which can improve the efficiency of the motor MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL FR-A740-30K-CHT Manual.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. Function expansion board for RS-232C communication MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL. Voltage level: three phase 400V.
Applicable motor capacity: 355kw.
Substrate coating: have.
Built in DC reactor.
The operating frequency of the fixed alternating current is converted to DC power. MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 1.5KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible.
Transducer can be used to drive a single phase motor? Can single phase power supply be useed?
Basically can not be used FR-A740-30K-CHT PLC FUNCTION PROGRAMMING MANUAL. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FR-A740-30K-CHT Manual.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft.