MITSUBISHI
Network module
A1SJ71QLR21

3C-2V/5C-2V coaxial cable between double loop PC (control station / common station) / remote I/O network (remote master station). Q mode.

MITSUBISHI
Master control module
A1SJ71T32-S3

Cable type: twisted pair. A1SJ71PT32-S3 and A1SJ71PT32-S3 are the main control module of MELSECNET/MINI-S3, The main PLC in the network can control 64 remote I/O modules.

MITSUBISHI
Computer communication module
A1SJ71UC24-PRF

Interface: RS232C. Transmission distance: 15 meters.

MITSUBISHI
Computer communication module
A1SJ71UC24-R2

Interface: RS232C. Transmission distance: 15 meters.

MITSUBISHI
MODBUS interface module
A1SJ71UC24-R2-S2

Data format: ASCII. Data bits: 7.

MITSUBISHI
Computer communication module
A1SJ71UC24-R4

Interface: RS422/485 Transmission distance: 500 meters A1SJ71UC24-R2/R4/PR computer communication components can be relied on external intelligent devices such as computers and PLC for communication, the components are as follows: Full / half duplex transmission, 4 special communication protocols, No protocol and bidirectional mode, Protocol selection switch function, The optional baud rate, the highest 19.

MITSUBISHI
MODBUS interface module
A1SJ71UC24-R4-S2

Data format: RTU. Data bits: 8.

MITSUBISHI
Modular
A1SJ72J95

JEMANET (OPCN-1) interface unit from the station. The response time of PLC is the interval between the time of the change of the external output signal of the PLC and the time of the change of the external output signal which is controlled by it, Lag time, this is the time constant of the input circuit, The time constant of the output circuit, the arrangement of the user statement and the use of the instruction, The cycle scan mode of PLC and the way of PLC to refresh the I/O and so on.

MITSUBISHI
Network module
A1SJ72QBR15

3C-2V/5C-2V coaxial cable single bus remote I/O network (remote I/O station). Q mode.

MITSUBISHI
Network module
A1SJ72QLP25

SI/QSI/H-PCF/ wide H-PCF optical cable dual layer remote I/O network (remote I/O station) Switch volume control is designed to, According to the current input combination of the switch quantity and the history of the input sequence, So that PLC generates the corresponding switching output, In order to make the system work in a certain order. So, sometimes also known as the order control.

MITSUBISHI
Network module
A1SJ72QLR25

3C-2V/5C-2V coaxial dual ring remote I/O network (remote I/O station). Q mode.

MITSUBISHI
Melsecnet remote interface module
A1SJ72T25B

By MELSECNET/B I/O can be decentralized control. In a main PLC station this module can control up to 512 I/O points.