Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).Apply to GLC-2600/2500Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.I/O module, including 32 point NPN/PNP inputColorful LED switch with USB interface.The main controller is directly connected to the man-machine interface (D-sub 9 pin concave) for multiple connection (n:1) communication Proface CA7-HTBCNSET-01 CA7-HTBCNSET-01 For thin film surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)For connecting GP operation data with D-Sub RS-232C and power /DIO terminals.The man-machine interface directly connected MITSUBISHI electric PLC QnA series A/ CPU programming port Proface CA7-HTBCNSET-01. 3.4 Inch Touch Screen anti UV protective film (1 pieces).Portable GP2000H series models accessories, RS-422 single head cable (10 m).Touch screen anti ultraviolet protective film (1 pieces).Portable GP2000H series models accessories, RS-422 single head cable (3 m).Fitting on NETWORK FLEX interface. Connecting NETWORK FLEX communication cable. (5 / set)Converting 4 analog signals into digital signalsExpansion module for the GP3000 access to the CANopen network and communication with the CANopen master stationFor 3 Proface CA7-HTBCNSET-01. 8 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)One end is a loose wire, which is used to carry out RS-232C connection between the host and LT.Portable GP2000H series models accessories, RS-232 cable with D-Sub connector (10 meters).The MITSUBISHI A series PLC is connected to GP, length: 5 m.A connector that connects the DIO interface for connecting an external I/O device (5 seets) CA7-HTBCNSET-01. Touch screen anti ultraviolet protective film (1 pieces).Cable for transmitting an image signal from an Pro-face host to a Pro-face industrial display or other commercial display device (24- DVI-D pin convex).Used to install thee man-machine interface to the fixed panel CA7-HTBCNSET-01. (4 / set)The man-machine interface directly connected MITSUBISHI electric PLC Q series CPU programming port.