I/O module, including 32 point NPN/PNP inputOne end is a loose wire, which is used to carry out RS-232C connection between the host and LT.Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).Portable GP2000H series models accessories, RS-422 single head cable (10 m).7.5 inches /3.8 inches /5 Proface GP3000H-CBLS-10M. 7 inches, used to connect the power cord (5 / sets).5.7 inches, installed to provide the function of dust and moistureUsed to install the human machine interface to the fixed panel (2 / cover) GP3000H-CBLS-10MProtection for GP rear connectors (large and small for each of the 1).Used to prevent disconnection of the connection (1 interface, 5 / set).Replaceable anti fouling film for protecting screen protective film (5 sheets / cover) Proface GP3000H-CBLS-10M. NETWORK FLEX 64 point DIO connector terminal block, (including 2)Adapter for EX module (5 / set)Expansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master stationApplicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).COM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connectionTo prevent the connection of disconnected USB cable fastening clips (Mini-B USB, 1 interface, 5 / set)Connector for connecting DC power cord (5)The main body module and the separate display module are used for connecting the main machine module and the separate display module in the DIN guide rail Proface GP3000H-CBLS-10M. With the installation of screws (4 / sets), for the GP4000 series back mounted to the fixed panel models. (2 / set)5.7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)Touch screen anti ultraviolet protective film (1 pieces).For the operation screen (5 pieces) (GP3000H staandard) GP3000H-CBLS-10M. 5.7 inch screen protective cover (1 pieces)Connector for connecting DC power cord. (linear, 5 / set)Standard cable for connecting GP3000H adapter and GP3000H.
Length: 10 meters. For connecting the GP3000H cable connector andd the external output port, the output of the following connectors: serial: D-Sub 9 pin (convex), Ethernet: Jack RJ-45 (Modular), other: terminal block GP3000H-CBLS-10M.