Max input / output points: 10 points.
Supply voltage: 100 - 240VAC.
Input points: 6 points.
Output points: 4 points.
Output type: Transistor (source).
Power consumption (W): 6.
Weight (kg):0.22.
Size (WxHxD) mm:60x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types MITSUBISHI FX2NC-ENET-ADP.
This type of PLC is mainly used in all of the digital input, digital output control point of the device FX2NC-ENET-ADP
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O MITSUBISHI FX2NC-ENET-ADP.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication. Length: 55mm.
Function: connect GM-FX.
Corresponding models: FX2N-10GM, FX2N-20GM. Total points: 14 points.
Input points: 8 points.
Output points: 6 points.
Voltage: AC220V.
Output type: relay.
Outline dimension: 60*75*90 MITSUBISHI FX2NC-ENET-ADP.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX2NC-ENET-ADP MITSUBISHI FX2NC-ENET-ADP MITSUBISHI. Length: 3 meters.
Specification: cable. Function extension board for RS-232C communication.
No DC24V consumption, do not take up input and output. Input and output points: 30 points.
Power supply: AC100-240V.
Input points: 16 points.
Output points: 14 points.
Output form: relay output.
Power consumption: 21W FX2NC-ENET-ADP MITSUBISHI.
Weight: 0.45KG.
Outline dimension: 100x90x75mm.
A new application model.
FX3SA is a basic model on the bassis of the basic performance of FX1S above the expansion of the expansion of the new model FX2NC-ENET-ADP.
FX3SA is applicable to all kinds of fields of small scale equipment which need to simulate the quantity and function of MODBUS and Ethernet MITSUBISHI FX2NC-ENET-ADP.
Basic models suitable for small scale control.
Compact but powerful,
At the same time, the analog quantity and communication function, etc..