Memory format: EEPROM.
Number of steps: up to 16000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device. Display: 16 characters x 4 lines.
Can monitor, change the value of software components FX2N-1RM-E-SET MITSUBISHI.
Can also be simple to operate, change the value.
Equipped with a button operation can be used (operator certification function) and control through the PLC control function,
Can be used with the function expansion board FX2N-1RM-E-SET
Can be installed directly to the FX3GA, FX3G, FX3GE, no wiring. Total input and output points: 8 points.
Output points: 8 points.
Output type: transistor output.
FX Series in the compact body built in superior performance, and strive to operate simple FX2N-1RM-E-SET MITSUBISHI.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication FX2N-1RM-E-SET MITSUBISHI.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit. Signal level: the DC5V, 12V, and 24V differential output can be connected to the DC5V terminal by connecting terminals.
Applicable PLC:FX1N, FX2N, FFX3U, FX2NC (to FX2NC-CNV-IF) FX2N-1RM-E-SET.
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
Can be single phase, dual phase 50kHz hardware counter high-speed input.
High speed uniform output function with hardware comparison circuit.
In thhe dual phase count, 1, 2, and 4 multiplication modes can be set FX2N-1RM-E-SET.
Can be licensed and reset by PLC or external input.
Differential output type encoder.