Type: HA-SE series.
Rated output: 3.5KW.
Rated speed: 2000r/min.
Electromagnetic brake: No.
Control complex, easy to achieve intelligent,
The electronic commutation method is flexible and can be changed by square wave or sine wave.
Motor maintenance free, high efficiency, low operating temperature,
Electromagnetic radiation is very small, long life, can be used in a variety of environments MITSUBISHI MR-ENCBL2M-H MR-ENCBL2M-H
AC servo motor is brushless motor, which is divided into synchronous and asynchronous motor,
Synchronous machines are commonly used in motion control,
Its power range, you can do a lot of power.
Large inertia, the maximum rotation speed is low, and with the increase of power and rapid reduction.
So it is suitable for the application of low speed and stable operation MITSUBISHI MR-ENCBL2M-H.
The rotor of the servo motor is permanent magnet,
Drive controlled U/V/W three phase electric electromagnetic field,
The rotor rotates under the action of the magnetic field,
At the same time the motor comes with the encoder feedback signal to the drive,
According to the feedback value and the target value, the driver is compared,
Adjust the rotor rotation angle MITSUBISHI MR-ENCBL2M-H.
The accuracy of the servo motor is determined by the accuracy of the encoder. Motor series: ultra low inertia, low power.
Rated output power: 0.2kw.
Rated speed: 3000r/min.
Whether to bring the brakes: with MR-ENCBL2M-H MITSUBISHI.
Shaft keyway: (open slot).
Protection level: IP55 does not include the shaft part and the connector.
Features: ultra low inertia is suitable for high frequency operation MR-ENCBL2M-H MITSUBISHI.
Application examples: the insertion device, the assembly machine. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 15KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is sinngle MR-ENCBL2M-H MITSUBISHI MR-ENCBL2M-H.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop ccontrol system MITSUBISHI MR-ENCBL2M-H.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter.