GLC2300 is not availableThe main controller is directly connected to the man-machine interface (D-sub 9 pin concave) for multiple connection (n:1) communication.The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module.5.7 inches, replace the backlight (1 / set)12 Proface AGP3000H-ADPCOM-01. 1 inches, replaced by a host of backlight (1) AGP3000H-ADPCOM-01Used to convert the USB interface to the serial interface (RS-232C). A modem or bar code reader that can be connected to support RS-232C.Direct interface Matsushita Electric PLC FP series CPU port.Screen protection cover (1 pieces) for protecting screen against pollution of man-machine interface10.4 inches (TFT), the replacement of the host backlight (1) Proface AGP3000H-ADPCOM-01. The main controller is connected to the man-machine interface for MPI communicationTo prevent the connection of disconnected USB cable fastening clips (Type-A USB, 1 interface, 5 / set)Used to interface the main machine output serial port (D-sub 9 pin concave type) directly connected to the RS-422 terminal block.Transmission screen data, such as the USB cable, PC (Type-A USB) to the man-machine interface USB (Type-A)Used for converting the D-Sub 9 pin convex joint to the D-Sub 25 pin concave jointA1/A2/B+ DIO Type connector (compression type) (5 / set)Adapter for EX module (5 / set)12 Proface AGP3000H-ADPCOM-01 AGP3000H-ADPCOM-01 Proface. 1 inches, replace the backlight (1 / set)Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).A veneer, for the GP4000 series back loading models of full flush (white, 1)Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceInput / output hybrid I/O modules, including 16 point NPN/PNP input and 16 point PNP transistor outputWhen the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function AGP3000H-ADPCOM-01 Proface AGP3000H-ADPCOM-01 Proface AGP3000H-ADPCOM-01. (1)The module is used for mounting on the back board of the GLC2000 series host computer Proface AGP3000H-ADPCOM-01. Then you can install the GP77R series or GLC100 series of medium size expansion module in the module on the outward side.