Output: DPDT.
Lighting: LED.
Operating voltage: 24 VAC/VDC.
Pushbutton colorsymbol: R: red, Y: yellow; PY: pure yellow
G: green, A: blue; PW: pure white; B: black *2.
Item: Alternate operation (Self-holding).
Separate Construction with.
Cylindrical 16-dia. Body.
Miniature design of 28.5 mm, the smallest class in the industry .
Detachable Switch E6A2-CS3E 10P/R 2M.
The same contacts can be used for both standard loads and microloads E6A2-CS3E 10P/R 2M
Easy-to-wire terminal arrangement.
Certified for EN 60947-5-1. Size: M12, Non-shielded.
Sensing distance: 8.0 mm.
Connection: M12 connector.
Body material: Brass.
Thread length (overall length): 56 (70).
Output configuration: NPN E6A2-CS3E 10P/R 2M.
Operation mode NC.
Safe Mounting with Greater .
Sensing Distance.
Ensures a sensing distance approximately 1.5 to 2,
times larger than that of any conventional OMRON Sensor.
Problems such as the collision of workpieces are eliminated.
Full range of standard sizes (M8, M12, M18 and,
M30; both long and short barrels).
Modular construction simplifies customization. Control terminal block: Terminal block with small slotted screws E6A2-CS3E 10P/R 2M.
Type: Standard.
Capacity: 20 A, 100 to 240 VAC.
Heater burnout detection: No.
Communications: No.
High-precision Control with Easy Setup,
Precise heater burnout detection.
Set value and present value monitoring with indicators.
Phase control or optimum cycle control.
RS-485 communications to set manipulated variables and,
monitor load current.
Total run time monitoring.
Output modes for phase control: proportional to phase angle,
proportional to voltage, proportional to square voltage,
and constant-current control.
Application with various loads: constant load resistance,
variable load resistance.
UL, and IEC/EN (TÜV) certified. Servo trunk unit.
Product Name: servo relay unit.
Application unit: CJ1M-CPU21/22/23.
Specifications: -.
Axis number: biaxial.
The connector and terminal of the relay unit are integrated into a whole,
Save the wiring servo drive and positionn control unit E6A2-CS3E 10P/R 2M.
Seervo driver and control signal of position control unit,
Simple wiring on terminal stage .
The connector without soldering, with only a screwdriver can wiring.
Dedicated connection cable between units.
DIN guide rail installation, the rapid installaatiion, screw installation of two methods E6A2-CS3E 10P/R 2M.
M3.0 thread terminals attached with a special plate signal.
The terminal can be confirmed by the signal name.

E6A2-CS3E 10P/R 2M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=E6A2-CS3E 10P/R 2M&select=5