Applicable model (typical example): MY4.
New Screwless Terminal Sockets Added.
for MY and G2R Relays.
Simplified wiring without tightening screws.
Two wires can be independently wired for each terminal.
Coil terminals and contact terminals are completely separated,
in an organized wiring layout .
Release Levers and Nameplates are available (sold separately) DCA2-5CN05W1. Appearance: Shielded, M18.
Sensing distance: 8 mm DCA2-5CN05W1
Output: NPN.
Model: Operation mode NO.
Aluminum and Iron Both.
Detectable from Long Distances. Ratings: 1 A at 30 VDC.
LED indicator: With indicator.
Actuator: Center roller lever.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector DCA2-5CN05W1.
New center roller lever models that enable ganged mounting .
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection.
Operation indicators available for easy monitoring,
(standard indicator is lit when Switch is not operating).
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models DCA2-5CN05W1. )
Unit type: CS1 CPU Bus Units .
Product Name: MECHATROLINK-II,
compatible Position Control Unit.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder,
programming, Control mode:
Position control, speed control,
or torque control; No. of axes: 2.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.36A; 26V, --.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
and Batch Management.
Control Servos for up to 16 axes,
in a motion network with one Position,
Control Unit that supports MECHATROLINK-II.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association. Release key type: Special release key.
Indicator: Green.
Lock and release types: Mechanical lock Solenoid release.
Contact configuration(door open/closed detection switch,
and lock monitor switch contacts): 3NC+2NC/1NO.
Conduit opening: G1/2.
Holding FForce of 3,000 N DCA2-5CN05W1.
Two ssafety circuits and two monitor contacts provide an,
array of monitoring patterns .
Standard gold-clad contacts enable use with ordinary loads,
and microloads.
Models with trapped keys prevent workers from being locked,
in hazardous work areas. .
Models with rear release buttons allow people to unlock the,
Switch and escape if they are locked into hazardous areas DCA2-5CN05W1.
IP67 degree of protection.
DCA2-5CN05W1 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=DCA2-5CN05W1&select=5