A New High-performance Controller: High Resolution, High Speed,
and High Input Accuracy.
Logic Operations and Preventive Maintenance Function.
Plus Infrared Port on Front Panel.
High-resolution display with 5 digits/0.01°C display.
High-speed sampling cycle of 60 ms.
High Accuracy.
Thermocouple/Pt input: ±0 . 1% of PV,
Analog input: ±0 FZ4-L355-10. 1% FS,
Universal inputs on all models (thermocouple, PT, or analog,
input) to handle various sensors with one Controller FZ4-L355-10 Models,
also available with Remote SP.
A PV/SV-status display function can be set to automatically alternate,
between displaying the status of the Temperature Controller (auto/
manual, RUN/STOP, and alarms) and the PV or SV FZ4-L355-10.
Flexible contact outputs with logic operations (AND, OR, and,
delays) set from the Support Software (CX-Thermo Ver . 4.0),
Preventive maintenance for relays in the Temperature,
Controller using a Control Output ON/OFF Counter.
Model available with position-proportional control. Model: Shielded, M12.
Sensing distance: 2 mm.
Output configuration: DC 3-wire, NPN FZ4-L355-10.
Model: Operation mode, NO.
Proximity Sensor with Resin Case,
with Superb Water Resistance .
IP68 protection.
Mutual interference prevention with models with different,
frequencies is also available. Time specification: Inverse type.
Current setting range: 8 to 26 A.
Operating voltage: 200/220/240 VAC.
Resetting method: Manual.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set timme value can be checked eeasily because operation time,
is indicated from the start of operation FZ4-L355-10.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequeenccy, basic,
frequency, and load conditions FZ4-L355-10. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
FZ4-L355-10 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FZ4-L355-10&select=5