Short/disconnection detection: Supported.
Specifications: Inputs, NPN (+ common), 16 points.
I/O connections: Clamp terminals.
Rated internal circuit power supply voltage:
Supplied from communications connector.
Rated I/O power supply voltage: 24 VDC.
Reduced Wiring and Labor on Factory Sites with Screw-less Terminal Wiring .
Screw-less structure eliminates tightening work E2EQ-X10D1-M1J 0.3M.
Detachable terminal blocks for easier maintenance E2EQ-X10D1-M1J 0.3M
Single-step wiring by simply inserting pole terminals. Type: square.
Screen mode: no segmentation.
Using voltage: DC12V.
Operation Department color: Blue (using yellow and green LED).
Micro design, the length of the body is only 23mm E2EQ-X10D1-M1J 0.3M.
LED has five colors (red, yellow, green, white, and blue) .
Chip LED to produce a uniform surface brightness.
From the front panel installation, more convenient. The main body: terminal type, temperature input type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: voltage output (SSR driver).
Control mode: standard or heating cooling E2EQ-X10D1-M1J 0.3M.
Auxiliary output points: 2 points .
The heater is used to break, SSR fault, heater over current detection function /ES1B power supply: single phase or three phase heater with detection function.
Event input points: -.
Transfer output: -.
Communication: RS-485.
48mm general thermostat has been upgraded & function / performance upgrade.
Indicates that the accuracy is increased and the preventive maintenance function is increased,
Further performance improvement.
E5CN-U (insert type) add analog input and current output type.
Add PV/SV status display function, convenient to check the state off the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV E2EQ-X10D1-M1J 0.3M.
Increase the number of control output ON/OFF counting function, can prevent the maintenance of temperature controller internal relay. Power Supply: Model, S82J; Capacity, 25 W.
EEassy-to-use DIN Rail Mounting Bracket for,
Power Supplies E2EQ-X10D1-M1J 0.3M.
Mounts to the PFP-100N and PFP-100N2 DIN Rails.
Supports models S82J (100, 150-W models).
E2EQ-X10D1-M1J 0.3M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=E2EQ-X10D1-M1J 0.3M&select=5