Actuator: Resin rod (rod diameter: 8).
Indicator: Neon lamp.
Item: Basic.
Pretravel (PT): 40±20 mm.
Select the Best Two-circuit Switch for the,
Operating Environment and Application,
from a Wide Range of Models,
A wide selection of models is available, including General-purpose,
Environment-resistant, and Spatter prevention Switches E2E-C06N04-WC-B1 2M.
Standard-feature gold-clad crossbar contacts provide high reliability E2E-C06N04-WC-B1 2M
Applicable to either standard loads or microloads.
Switches with Lever Actuators provide 90° overtravel,
one-side operation, and four-direction head mounting.
Approved standards: EN/IEC, UL, cUL, and CCC.
Contact your OMRON representative for information on approved models E2E-C06N04-WC-B1 2M. Contact type: Standard load (250 VAC, 3 A; 30 VDC, 4 A) .
Operation: Alternate operation (Self-holding).
Case color: Light gray.
Output: SPDT.
Lighting: Incandescent lamp; 14 VDC/VAC.
Pushbutton color symbol: R.O.G.W.
Large Square-bodied Lighted.
Pushbutton Switches.
Excellent operating sensitivity.
Excellent illumination with even surface brightness E2E-C06N04-WC-B1 2M.
Three-color models (green, orange, red; chameleon lighting) .
included in lineup. Size: 48 x 96mm.
Type: power AC/DC24V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event entry point: 2.
Transfer output: -.
Remote SP:4 to 20mA input.
Communication: RS-422.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm), interactive display PV/SV.
Through the suppport software (VVer E2E-C06N04-WC-B1 2M.4.3 CX-Thermo) makes the process of setting management becomes very
Simple use of simple computing functions (AND/OR logic and delay) to set the implementation of flexible contact output.
Through the infrared port can be carried out from the frronnt of the communication E2E-C06N04-WC-B1 2M.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller.
E2E-C06N04-WC-B1 2M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=E2E-C06N04-WC-B1 2M&select=5