Appearance: Shielded, M12.
Sensing distance: 2 mm.
Output configuration: DC 2-wire, (1)-(4) pin arrangement.
Model: Operation mode, NO.
Chip-immune Inductive.
Proximity Sensor.
Correct operation even with aluminum or iron chips sticking,
to the Sensor.
Only the sensing object is detected.
Pre-wired Smartclick Connector Models also available E2A-S08LS02-WP-B2 2M. Slit width: Width 1 × 10 mm.
Installation procedure: Plug-in type E2A-S08LS02-WP-B2 2M
Applicable type: E3Z-T@@. Size: 96 x 96mm.
Control output 1: voltage output (SSR driver).
Control output 2: relay output.
Auxiliary output: 2 independent points.
Power supply voltage: AC100 ~ 240V.
Terminal shape: screw terminal table type E2A-S08LS02-WP-B2 2M.
Input category: full range multi input .
Heating wire break, SSR fault detection function: 2 point (three phase heater).
Communication: RS-485.
Event input: 2 points.
Remote SP input: -.
Transfer output: -.
Large screen display white PV legible. From selection to setting and operation are simple and easy to use.
Full capacity, function and performance of I/O. Suitable for more applications E2A-S08LS02-WP-B2 2M.
E5AC white LCDPV display height is about 25mm .
The upper panel and the front panel are equipped with tool ports.
With the communication conversion line (sold separately) connected to the computer to establish the controller without the need to install the wire for power supply.
Easy to install CX-Thermo (sold separately).
50ms high speed sampling period.
Model can be equipped with up to 4 point auxiliary output, 6 point event input,
1 point transfer output and remote SP input, suitable for a wide range of applications.
The main body is short, the thickness is only 60mm.
Easy to use programmable logic controller (PLC) is connected to the programmable logic controller (PLC).
The temperature controller is connected to each other by using the component communication.
A new type of proportional control allows you to control the valve. Size: 45 × 35 mm.
Type: Plug-in.
Control method: OON/OFF operationn E2A-S08LS02-WP-B2 2M.
Control output: Relay.
Power supply voltage: 100 to 240 VAC.
Ideal for Simple Built-in Control.
A high switching capacity of 10 A at 250 VAC enables,
direct load switching.
A sensor is provided to enable immediate application.
Sockets wiithh finger protection (PTF14A-E) or without,
finger protection (PTF14A) can be used E2A-S08LS02-WP-B2 2M.
Simple operation and settings. Even simpler with digital models.
E2A-S08LS02-WP-B2 2M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=E2A-S08LS02-WP-B2 2M&select=5