SI-200/250 fiber optic cable.
Double loop.
MELSECNET (II) (remote I/O station).
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system MR-E200AG
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc MR-E200AG. . Oil resistant cap for 10.4 inch screen.
Applicable model: GT16. Input: 2 channels.
500/200/100/10kpps.
Counter input signal: DC5/12/24V.
External input: DC5/12/24V.
Uniform output: Transistor (drain type).
DC12/24V.
0.5A/ point.
2A common end MR-E200AG.
40 pin connector. Cable length: 10m .
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. Function extension board for RS-232C communication.
No DC24V consumption, do not take up input and output. Through a series of holes available to install FR-A800 using the original FR-A500 series.For A6TBXE/A6TBY36E/A6TBX54E/A6TBY54E/A6TBX70E (common cathode; source) long 1m.Motor series: medium inertia, medium capacity.
Using a serial absolute / incremental encoder.
Rated output power: 0.85kw.
Rated speed: 1000rpm.
With the brake: without.
Shaft end: straight shaft.
The structure of the AC servo motor stator is bbasically similar to the capacitor split phase single-phase induction motor MR-E200AG.
The stator is provided with two positions of 90 degrees of mutual difference of the winding, one is the excitation winding Rf, it is always connected to the AC voltage Uf;;
TThe other is to control the winding L, which is connected to the control signal voltage Uc MR-E200AG.
So the AC servo motor, also known as the two servo motor.
MR-E200AG Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-E200AG&select=5