Operation control mode: stored procedure repeated operation.
Input / output points: 4096 points.
Program capacity: 160K step.
Multi CPU system for high precision motion control
The high speed control can be realized by executing the parallel control program and the parallel processing of multi CPU high speed communication .
The communication cycle between multi CPU has been synchronized with the motion control time, which can reduce the redundant control time HC-SFS52G2 1/45
After installing the 3 motion CPU modules, the maximum of 96 axes can be used for servo control.
Program capacity of up to 1200K.
Multi CPU system for high precision motion control.
The built-in CPU module support 2 Gigabit Network port HC-SFS52G2 1/45.
Database functions to facilitate data management.
Extended SRAM card with built-in security function.
Can be carried out a variety of motion control (position, speed, torque, advanced synchronous control, etc.).
In line with the international safety standards (13849-1 PL e ISO, IEC 61508 SIL 3) security CPU.
The most suitable for C/C++ language programming from the computer / computer environment for transplantation HC-SFS52G2 1/45. 8 slots; requires 1 AnS series PLC power modules;
Used to install large AnS series PLC module.
Base plate of AnS series PLC.
QA1S series PLC 8 slot main substrate.
AnS series of modules can be installed. Memory card interface (AD59-MEF), parallel interface.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the inpput device, and then connect the output device, and then connect to the actual load and so on and so on step by step HC-SFS52G2 1/45.
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the progrramm can be HC-SFS52G2 1/45. Cable length: 5m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-L represents bending life.
HC-SFS52G2 1/45 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=HC-SFS52G2 1/45&select=5