Length: 15 meters.
Cable manufacturing specifications.
When there is no connection options, according to the table under the cable.
Using a parallel connection or a large size cable for connection between the terminal PG" and "SD" and the motor end encoder. "MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series .
Rated output: 7 HC-MFS/KFS23G1(1/20). 0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for linear servo motor HC-MFS/KFS23G1(1/20)
Power specification: three phase AC400V.
More advanced real-time automatic tuning by setting response values,
Including the position gain and the gain of speed, all the gain can be adjusted automatically HC-MFS/KFS23G1(1/20).
32 segment response level can be set.
Advanced vibration suppression control .
An optimal vibration control filter value is automatically set by the automatic tuning function to effectively suppress the vibration of the 100Hz frequency that occurs when the driving part stops.
The automatic tuning function can effectively restrain the vibration of the end of the mechanical arm and reduce the residual vibration in the machine HC-MFS/KFS23G1(1/20). Superior high efficiency IPM motor .
Output power: 11kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 2.2kw.
SLD converter rated current: 16.7A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacemeent operation HC-MFS/KFS23G1(1/20).
((rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station .
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme,, used in the control of the external machine HC-MFS/KFS23G1(1/20).
No external PID controller is used to control the external machine, so the system cost can be reduced.
HC-MFS/KFS23G1(1/20) Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=HC-MFS/KFS23G1(1/20)&select=5