Servo motor series: low inertia, medium and large capacity.
Rated output: 3.5kw.
Rated speed; 3000r/min.
Electromagnetic brake: No.
Power supply: 400V.
Most suitable for medium and large capacity, low inertia type products in high frequency operation or acceleration and deceleration operation.
Improve the environmental performance of HG-SR, HG-JR series of products using IP67 AC20R4-A8PU.
High speed & high torque AC20R4-A8PU Shorten the positioning time, achieve high-speed equipment.
100 scene, there are 100 different drive control.
In order to meet the needs of the diverse and detailed field,
MR-J4 product line configuration, providing a wealth of servo amplifier and servo motor products AC20R4-A8PU.
Can meet the different needs of different customers . Motor: HA-SH type.
Power: 3.5kw.
Speed: 2000r/min.
The speed regulating motor can be divided into a constant speed motor, a stepless constant speed motor, a stepless speed changing motor and a stepless speed changing motor,
Can also be divided into electromagnetic induction motor, DC motor, PWM variable frequency motor and switched reluctance motor AC20R4-A8PU.
The rotor speed of the induction motor is always slightly lower than that of the rotating magnetic field .
The rotor speed of the synchronous motor is not independent of the load size, but is always maintained as a synchronous speed. DC input points: 16 points.
Input voltage and current: 5mA, DC24V.
Response time: 10ms.
16 point /1 a public side.
Positive / negative sharing.
Output points: 16 points.
Output voltage and current: DC24V, 0.1A/1 point, 1.6A/1 common end.
Response time: 2ms.
16 point /1 a public side.
Output form: transistor output, leakage type.
40 pin connector.
Number of stations: 4 stops.
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC detection, fault diagnosis and display and other procedures.
These procedures are relatively independent, generally in the basic completion of the program design and then add.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end oof the PLC system in a haard wired way, and the timeliness is strong AC20R4-A8PU.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too gguarantee the timeliness AC20R4-A8PU.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.
AC20R4-A8PU Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AC20R4-A8PU&select=5