The length of the line: 5M.
IP level: IP65.
Cable lead out direction: motor shaft different side.
Bending life: high bending life.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Protective film for 10.4 inch screen.
Transparent, 5 .
Applicable model: GT16. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MR-J4-100A-RJ.
Rated output: 0 MR-J4-100A-RJ2kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: single phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed MR-J4-100A-RJ.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder.
The use of a flexible linear servo motor drive components can make the system more compact structure.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent magnet) of the motor,
So linear servo motor is especially suitable for large range of applications MR-J4-100A-RJ. In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation. Memory format: flash memory.
Number of steps: up to 64000 steps.
Battery support: do not.
Write, delete method: installed on the PLC through the peripheral devices to write, delete. Output points: 32 points.
Output type: leakage type.
Rated output voltage: DC12 ~ 24V.
Max load current: 0.1A/1 point.
Protection function: have.
Common way: 32 point / public end.
Input / output occupied points: 32 points (I/O distribution: output 32 points).
External wiring connection mode: 40 pin connector.
The switch input and output module is aa device which can colllect the input / output of the switch signal,
Digital I/O modules are often called MR-J4-100A-RJ.
The switch signal is collected to the computer or the computer to send the relevant instructions through the RS-485 bus to control the switch of the switch,
Can alsso be carried out through the RS-485 bus communication,
Remote control switch MR-J4-100A-RJ.
Communication protocol is a standard Modbus protocol or custom protocol.
MR-J4-100A-RJ Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J4-100A-RJ&select=5