Size: 96 x 96mm.
Type: power AC/DC24V with.
Shell color: black.
Control output 1: built-in SSR output.
Control output 2: built-in SSR output.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater A16L-JWM-12-1.
Event entry point: 2.
Transfer output: transfer output (special terminal) A16L-JWM-12-1
Remote SP:4 to 20mA input.
Communication: RS-232C.
General thermostat new high performance (high resolution, high speed, high precision input) type products.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved A16L-JWM-12-1.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV A16L-JWM-12-1.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type. E3JK-R41J regression reflection type,
E3JK communication mode: mode; ON,
Miniature amplifier built-in type photoelectric switchRatings: 1 A at 30 VDC.
LED indicator: Without indicator.
Actuator: Pin plunger.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick wwith Connector A16L-JWM-12-1.
New ceenter roller lever models that enable ganged mounting .
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection.
Operation indicators available for easy monitoring,
((sttandard indicator is lit when Switch is not operating) A16L-JWM-12-1.
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.)
A16L-JWM-12-1 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=A16L-JWM-12-1&select=5