Cable length L: 0.25 m.
Connect Connector-Terminal,
Block Conversion Units (XW2@) to,
I/O Units for Programmable,
Controllers with one touch. Size: 48 * 48mm, terminal type.
Category: control output 1 point type (power supply AC100 ~ 240V).
Shell color: black.
Control output: voltage output (SSR driver) .
Control mode: standard or heating cooling H3JA-8C AC100-120 30S.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function H3JA-8C AC100-120 30S
Event entry point: 2.
Transfer output: -.
Communication: RS-485.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved H3JA-8C AC100-120 30S.
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV H3JA-8C AC100-120 30S.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can perform flexible contact output.
The control output ON/OFF times counting function can predict the fault of the internal relay of the temperature controller. Modular panel direct mounting type, easy to install and maintain the basic type.
The relay unit is modular and easy to maintain.
With LED action display function, so that the state of action at a glance.
Tropical treatment and high temperature.
Stable detection can be achieved with high ambient temperature.
Type: G3 type, both full of water, water shortage alarm function of automatic supply and drainage.
Package product name: 61F-G3 base * 1, 61F-11_ unit * 3.
Uses: 2 wire type. Appearance: Close-mounting.
Sensing method: Through beam type (with slot).
Connecting method: Connector model (4 poles).
Sensing distance: 5 mm (slot width).
Operating mode: Dark-ON/Light-ON (2 outputs).
Indicator mode: Incident light.
Model: PNP output.
Built-in connector enables,
downsizing and easier connection.
Protective circuit for safe operation.
A built-in connector minimizes the shape and dimensional,
requirements. H3JA-8C AC100-120 30S.
Two outputs:: light-ON and dark-ON .
Complete lineup including seven different shapes.
Safer operation with built-in power supply reverse polarity,
protection.
Output overcurrent protection with a thermal shutdown,
circuit (patent pending).
The indicator caan be seen from many directions to enable,
installation in more locations H3JA-8C AC100-120 30S.
Connector with lock that mates with commercially available,
connectors.
H3JA-8C AC100-120 30S Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=H3JA-8C AC100-120 30S&select=5