Fitting materials: Stainless steel (SUS304).
Count: 1.
Accessories: Description, xagonal bolts M4 (with spring and plain washers); Material, Iron, zinc plating; Count, 2.
Applicable sensor (mounting pitch on sensor side): E3S-C (25.4).
Page: Dimensions, 8.
Category: power FET MOS relay output.
Points: 16 points (1a * 16) .
Public connector side treatment: NPN (corresponding to the source of public) XS2F-D421-GC0-TR
Rated voltage: DC24V.
Pay attention to the use of convenience and space saving,
Relay terminal for 16 point output.
The terminal block is a long and thin type with a width of 135 * Deep 40mm.
It can be easily connected to the common end with the independent contact and short circuit chip XS2F-D421-GC0-TR.
Terminal units for power supply wiring processing can be extended .
M3.5 can be used with the Y fork type of the compression terminal (terminal width 6.2mm).
Can not use the tool to remove the relay. Relay replacement operation is simple.
Equipped with relay type and power FET MOS relay mounted type.
With action indication LED.
DIN guide rail installation, screw mounting common XS2F-D421-GC0-TR. Name: Expansion Units .
Specifications: Outputs;
8 outputs; PNP;
One Expansion Unit can be,
mounted to one CRT1-ID16(-1),
CRT1-OD16(-1), CRT1-ROS16,
or CRT1-ROF16 Digital I/O Slave.
Standards: CE, UC, UC1, N.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Servo trunk unit.
Product Name: servo relay unit.
Application unit: CS1W/CJ1W/C200HW-NC__3, C200H-NC.
Specifications: -.
Axis number: biaxial.
The connector and terminal of the relay unit are integrated into a whole,
Save the wiring servo drive and positiion control unit XS2F-D421-GC0-TR.
Seervo driver and control signal of position control unit,
Simple wiring on terminal stage .
The connector without soldering, with only a screwdriver can wiring.
Dedicated connection cable between units.
DIN guide rail installation, the rapid installaatiion, screw installation of two methods XS2F-D421-GC0-TR.
M3.0 thread terminals attached with a special plate signal.
The terminal can be confirmed by the signal name.

XS2F-D421-GC0-TR Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=XS2F-D421-GC0-TR&select=5