CC-Link-AnywireASLINK bridge module.CC-Link IE field network CC-Link bridge module.
Can support Ver.1 CC-Link remote I/O station and remote device station connected to the IE CC-Link field network.
CC-Link parameters can be set by a simple switch operation.
According to the original station number order, will be allocated to the bridge module of link equipment as CC-Link remmote station equipment distribution link NZ1MEM-4GBSD.
The IE CC-Link field network and the CC-Link loop transmission are independent of each other NZ1MEM-4GBSD.
The function module of MELSOFT Library (FB), the cache access bridge module,
To confirm and diagnose the running state of CC-Link.
SD memory card 4GB.
Can be used on the Q24DHCPCPU-V.
Can be used on the Q24DHCPCPU-LS.
Can be used on the QnUDVCPU.Capacity: 8MB NZ1MEM-4GBSD.Type: 18 point terminal.
Output form: transistor output, leakage type.
Output points: 16 points.
Rated input voltage / current: DC12/24V (0.5A).
External connection: 1 wire.
By using the output ON number of times, it is convenient to confirm the total number of ON of each output point MITSUBISHI NZ1MEM-4GBSD.
High speed input and output control of a single module can be realized by using first order logic function.
IE CC-Link field network remote equipment station. According to the equipment, more easily distributed input and output devices.
Can be connected to the expansion module, more convenient to expand the input and output points MITSUBISHI NZ1MEM-4GBSD.
Support synchronous communication (using with simple motion control module).
According to the simple motion control module of the network (Master) control cycle of the implementation of the control cycle and its synchronization,
Implementation of multiple simultaneous action from the station MITSUBISHI NZ1MEM-4GBSD. Type: sensor connector (e-CON).
Output form: transistor output, source.
Output points: 16 points.
Rated input voltage / current: DC12/24V (0.5A).
External connection: 3 wire.
By using the output ON number of times, it is convenient to confirm the total number of ON of each output point.
High speed input and output control of a single module can be realized by using first order logic function.
IE CC-Link field network remote equipment station. According to the equipment, more easily distributed input and output devices.
Can be connected to the expansion module, more convenient to expand the input and output points.
Support synchronous communication (using with simple motion control module) NZ1MEM-4GBSD.
According to the simple motion control module of the network (Master) control cycle of the implementation of the control cycle and its synchronization,
Implementation of multiple simultaneous action from the station.