Model : CV500-CN228.
BASIC for connecting the unit ← → FIT10 (2m).C1000HF-CPUA1 Omron Programmable Control CPU C1000HF-CPUA1-V1.
Unit name: Loop Control Boards.
Specifications: No. of function blocks:
50 blocks max.
Standards: UC1, N, CE.
The open nature of the PLCs is joined,
by integrating hardware, software,
and networking to meet your needs CS1W-LCB01.
Increasing amounts of information,
standardization, and open standards,
form the basis for achieving hardware,
and networking capabilities for process control CS1W-LCB01.
A wide range of software that can be easily,
used by design, development, and maintenance,
personnel makes operating and maintaining,
the system far easier. Name: Position Control Module.
Model: C200H-NC112.
Control method: Open-loop, automatic trapezoid acceleration/deceleration CS1W-LCB01.
Control output sig-nals: Pulse-train outputs.
Controlled axes: 1.Model: CPM2C-PA201. Input: 100 to 240 V AC.Output: 24 V DC/600 mA.Specification: Platinum resistance thermometer input (Pt100, JPt100),
manual operation,
ON/OFF or advanced PID control,
transistor (NPN) output, 4 loops OMRON CS1W-LCB01.Output method: Relay.
Inputs: 12.
Outputs: 8.Supply voltage: 100 to 120 or 200 to 240 VAC, 50/60 Hz
Output capacity: DC5V, 6.5AName: Three-tier Screw Terminal Block.
Specifications: Inputs; 8 inputs; PNP;
With Short-circuit and,
Disconnected Line Detection OMRON CS1W-LCB01.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system OMRON CS1W-LCB01.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Model: C200H-OD217.
No. of points: 12 pts.
Specifications: 5 to 24 VDC. source type (PNP).Unit type: CJ1 Basic I/O Units.
name: B7A Interface Units.
Specifications: I/O points, 64 inputs;
External connection, Removable terminal block.
No. of words allocated: 4 words.
Current consumption: 5V, 0.07A; 24V, --.
Standards: UC1, CE.
It transmits 16 points of I/O signals per,
word with a pair of cables.
Easy and minimized wiring effort,
The B7A Interface Unit and B7A Link Terminal,
can be used in the same way as a standard,
Basic I/O Unit and I/O Terminal without,
any need to worry about communications CS1W-LCB01.
This characteristic reduces the wiring,
when using more than one relatively remote,
sensor or actuator.