Superior high efficiency IPM motor.
Output power: 7.5kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power MR-J2S-37KA4 PDF.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. Fiber length: 20 meters.
SSCNET III cables (external standard optical fiber control cabinet) MR-J2S-37KA4
Joints for CN1A and CN1B. The length of the line: 20M.
Relay type.
IP level: IP20.
Bending life: high bending life.
Encoder with cable (amplifier side); for HF-KP/HF-MP series. Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series MR-J2S-37KA4 PDF.
Rated outpput: 30kw MR-J2S-37KA4 Manual.
Interface: universal type.
Power supply: three phase AC400V.
Special specifications: full closed control 4 wire / support mechanical end encoder ABZ phase input / support positioning mode.
Support position control, speed control, torque control MR-J2S-37KA4 PDF.
Position control to follow the position instructions.
When the control is inserted, the position control is performed.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque.
Function of switching amplitude MITSUBISHI SUPPLEMENTARY INSTRUCTION MANUAL. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth. Type: general purpose AC servo amplifier MR-E series.
Rated output: 0.4kw.
Interface type: general purpose pulse interface.
KH003 special mark for Super MR-E MITSUBISHI SUPPLEMENTARY INSTRUCTION MANUAL.
High performance and easy to operate, reduce work load.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder reesolution: 131072) MR-J2S-37KA4 SUPPLEMENTARY INSTRUCTION MANUAL.
High response.
Suppression of vibration by adaptive vibration suppression control.
Using personal computer and servo setup software to optimize tuning MITSUBISHI SUPPLEMENTARY INSTRUCTION MANUAL.
Has 2 types of interfaces:
Position control and speed control with pulse train interface MR-J2S-37KA4 Manual.
The analog input interface is used for speed control and torque control.