The length of the line: 2M.
IP level: IP67.
Bending life: high bending life.
Encoder cable for 15K1M, 11K1M4, HF-JP11K1M, 15K1M4. Cable length: 10m.
For MR-J2S-700A (4) /CP/CL or less MR-J2S-11KA PDF.
Encoder for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor.
-L represents bending life. The length of the line: 10M.
IP level: IP65.
Cable outlet direction: the same side of the motor shaft.
Bending life: standard MR-J2S-11KA
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). The length of the line: 0.3m.
Encoder with cable (motor side), for the HF-KP/HF-MP series (motor shaft with side extraction) MR-J2S-11KA PDF. MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 0.1kw.
Interface: SSCNET type.
Voltage: single phase AC200V.
MR-J2 series server system has the ability to carry out a higher precision control,
Using high performance CPU, greatly improve the responsiveness of the product,
Speed loop frequency response increased to 550HZ MR-J2S-11KA PDF.
Various series of servo motors are suitable for different control requirements,
The encoder on the servo motor supports ABS mode,

As long as the servo amplifier on the other plus batteries,
Can form an absolute position system MR-J2S-11KA Manual . MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MITSUBISHI Instruction Manual.
Rated output: 0.4kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: single phase AC100V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller MITSUBISHI Instruction Manual.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table MITSUBISHI Instruction Manual.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations MR-J2S-11KA Instruction Manual.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J2S-11KA Manual .
When the two stations are occupied, the speed can be set directly by the remote register.