Superior high efficiency IPM motor.
Output power: 3.7kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power MR-J2CN3TM PDF.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. Drive unit 200VAC/400VAC level.
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series MR-J2CN3TM
Need conversion unit MR-J3-CR55K) supporting the use of.
Rated output: 37kw.
Interface type: general pulse interface type.
Power specification: three phase AC200V.
Pulse train and analog input as universal interface MR-J2CN3TM PDF.
Can choose the position, speed and torque control mode.
The use of advanced tuning features such as advanced vibration suppression control and adaptive filter,
Greatly improve the performance of the machine.
MR-J3, your partner.
Higher performance, more features, more convenient to use MR-J2CN3TM PDF.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 2.0kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: three phase AC400V.
High precision and high response location control MITSUBISHI Installation Guide.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used in conjunction with aa number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MITSUBISHI Installation Guide MR-J2CN3TM Manual. ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system.
Flexible system configuration.
Can achieve higher load side positioning accuracy!"MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series MITSUBISHI Installation Guide.
Rated output: 3.5kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise MR-J2CN3TM Installation Guide.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servvo amplifier, which can form the absolute value system MR-J2CN3TM Manual.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. "