MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 1.5kw.
SLD converter rated current: 10.5A.
Structure and function: Standard model FX2N-128MT-ES/UL PDF.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FX2N-128MT-ES/UL
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same time, used in the control of the external machine FX2N-128MT-ES/UL PDF.
No external PID controller is used to control the external machine, so the system cost can be reduced. MITSUBISHI inverter FR-E740 series.
Voltage level: 3 phase 4400V FX2N-128MT-ES/UL Manual.
Frequency converter capacity: 1.5KW.
Allow short-time overload (200% 3S).
The machine itself does not need to purchase another operating panel FX2N-128MT-ES/UL PDF.
Provide USB interface to connect with the computer, you can use the FRConfigurator software to set the parameters of the inverter or monitor.
Inverter surface with PU interface, FR-E500 operating panel can be directly connected to the E700 series MITSUBISHI PROGRAMMING MANUAL II. The installation dimensions are in full agreement with FR-E500.
Allow side by side installation, saving installation space
Simple maintenance: equipped with comb type wiring board, wiring more convenient, the replacement of the same series inverter, no stitches, as long as the original inverter control terminal MITSUBISHI PROGRAMMING MANUAL II. 8 point analog potentiometer function expansion board.Function extension board for RS-485 communication.
No DC24V consumption, do not take up input and output. Voltage input: DC0~10V, DC0~5V.
Current input: DC4~20mA.
Voltage output: DC0~10V, DC0~5V.
Current output: DC4~20mA MITSUBISHI PROGRAMMING MANUAL II.
Applicable PLC::FX1N, FX2N, FX1NC, FX2NC (to FX2NC-CNV-IF) FX2N-128MT-ES/UL PROGRAMMING MANUAL II.
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
8 bit binary resolution analog input and output modules.
Input output mixed module with 2 channel analog input and 1 channell analog output FX2N-128MT-ES/UL Manual.
Voltage input and current input of 2 channels can be carried out.
1 channel analog output can be the output voltage or current output.