Length: 3 meters.
Operation panel or parameter unit connection line. Power: 7.5kw.
Voltage: 400V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor FX1N-24MR-D PDF.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available.
Please select according to the required braking torque FX1N-24MR-D Purpose: to operate, monitor, and change the parameters through the network.
Applicable frequency converter: FR-A700, FR-F700, FR-E700. Input expansion board (DC24V 4)
(FX1S and FX1N host general) FX1N-24MR-D PDF. MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 0.75KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
SSuch as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions FX1N-24MR-D PDF FX1N-24MR-D Manual.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operated at high precision in the super low speed region without the need of the encoder.
With torque control mode,
And in the speed control mode can use the torque limit function MITSUBISHI PROGRAMMING MANUAL II.
With vector control function (with encoder),
Frequency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc.) and torque control. MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V MITSUBISHI PROGRAMMING MANUAL II.
Frequency converter capacity: 55KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) MITSUBISHI PROGRAMMING MANUAL II FX1N-24MR-D PROGRAMMING MANUAL II.
If the given acceleration time is too short, the output frequency of the inverter is far more than thhe change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FX1N-24MR-D Manual.