Total input and output points: 16 points.
Output points: 16 points.
Output type: silicon controlled output.
FX Series in the compact body built in superior performance, and strive to operate simple FX1S-14MR-DS PDF.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application FX1S-14MR-DS
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FX1S-14MR-DS PDF.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FX1S-14MR-DS PDF.
The number of connection points depends on the basic unit and the expansion unit. MITSUBISHI inverter FR-E720 series.
Voltage level: 3 phase 200V.
Frequency converter capacity: 5.5KW.
In order to ensure the reliability of production, all production machinery in the design of power with drive, there is a certain amount of surplus MITSUBISHI HHARDWARE MANUAL FX1S-14MR-DS Manual.
When the motor can not run under full load, in addition to meet the requirements of power driven,
The surplus torque increases the active power consumption, resulting in the waste of electric energy.
Speed control method of fan and pump equipment traditional by regulating the entrance or exit of the baffle, valve opening to regulate air flow and water flow
, the input power is large, and a large amount of energy consumption in the baffle, the valve in the process of closure MITSUBISHI HARDWARE MANUAL.
When using variable frequency control, if the flow rate is reduced, the speed of the pump or fan can be reduced to meet the requirements MITSUBISHI HARDWARE MANUAL. MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 7.5KW.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be opeerated at high precision in the super low speed region without the need of the encoder FX1S-14MR-DS HARDWARE MANUAL.
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequuency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc FX1S-14MR-DS Manual. ) and torque control.