Input and output points: 24 points.
Power supply: AC100-240V.
Input points: 14 points.
Output points: 10 points.
Output form: transistor output (source) FR-A740-160K-CHT PDF.
Power consumption: 32W.
Weight: 0.55KG.
Outline dimension: 90x90x86mm.
FX3GE on the performance of the FX3GA increased analog input / output and Ethernet communication and other built-in features.
Applicable to a wide variety of applications FR-A740-160K-CHT
Basic unit: 24/40 point.
Third generation standard model.
High flexibility.
Suitable for small scale control of high cost PLC.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points FR-A740-160K-CHT PDF.
A versatile PLC.
Built in CPU, power supply, input and output, annalog input and output, Ethernet port, can be used immediately after the purchase FR-A740-160K-CHT Manual.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory FR-A740-160K-CHT PDF.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Maximum frequency: 200kHz.
Input points: 2 points.
Output form: transistor 4 point output.
Weight: 0.2kg.
1 FX3U-2HC can enter the 2CH high speed signal, can achieve the maximum count of 200kHz.
Through the comparison of the value of the PLC set, each ch with 2 points of high-speed output terminal MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL.
In the 2 phase count, can be set 1, 2, 4 frequency.
Can be achieved by PLC or external input to count the licensing / prohibition.
Can also be connected to the linear drive output type of the encoder.
FX3UC host connected to the FX2NC-CNV-IF, the need for FX3U-2HC or FX3UC-IPS-5V MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL. Function: RS-485 communication.
CPU module connected to the front of the expansion function of the substrate.
The front of the CCPU module can be connected to 1 units at most FR-A740-160K-CHT PLC FUNCTION PROGRAMMING MANUAL. Power: 75kw.
Voltage: 400V.
The power factor of the input power factor is up to 0 MITSUBISHI PLC FUNCTION PROGRAMMING MANUAL. 99 and above (100% load).
Can be connected to multiiple inverters, to achieve a common DC bus mode FR-A740-160K-CHT Manual.
Equipped with standard power retrogradation function. Length: 1.5m.
Specification: FX round connector.