MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 0.75KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible FR-A740-7 FR-A740-7.5K-CHT5K-CHT PDF.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FR-A740-7 FR-A740-7.5K-CHT Manual. 5K-CHT PDF.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Power: 15kw.
Voltage: 400V.
The surge voltage of the motor can be suppressed when the 400V motor is driven by a frequency converter FR-A740-7.5K-CHT PDF.
Motor suitable for 5.5 to 37kW. Connecting cable for handheld RH GOT and PLC.
Cable length: 1.5 meters.
Application: RS-232C connection (Q series (except for QnU). Needle number: 20.
Specification: loose wire connector, 5 sets (0 MITSUBISHI INSTRUCTION MANUAL. 3mm 2). Can be connected to the models: FX3SA, FX3S, FX3GA, FX3G, FX3GE.
Interface: RJ45 connector.
Weight: 0.02kg.
Can be equipped with the RS-485 communication function of the external equipment.
Carrying the RS-485 communication function between the PLC for communication MITSUBISHI INSTRUCTION MANUAL. Station type: intelligent equipment station.
Remote input / output: 128 points.
Remote register: 32.
Occupied points: 8 points.
Transfer speed: 10Mbps.
Power supply: 240mAA DC24V FR-A740-7.5K-CHT INSTRUCTION MANUAL.
Weight: 0.3kg.
FX3U-64CCL can be connected to the FX-PLC as an intelligent device station.
In addition, through the connection of the various manufacturers of machinery, can be used to set up the system MITSUBISHI INNSTRUCTION MANUAL FR-A740-7.5K-CHT Manual.
Can be connected to FX3GA, FX3GE, FX3GC, FX3U and FX3UC of the host.
Connecting FX3UC, FX3GC requires FX2NC-CNV-IF or FX3UC-IPS-5V.