MR-J2M multi axis servo amplifier drive unit.
Rated output: 0.1kw.
Servo system is used to achieve the following purposes:
1, with a small power command signal to control the power load. Gun control and rudder control is a typical example.
2, in the absence of mechanical connection, the input shaft control is located in the distance of the output shaft, to achieve remotee synchronous transmission MR-J40MA.
3, so that the output of the mechanical displacement of the precise tracking of electrical signals, such as records and instructions, etc MR-J40MA.. MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 0.6kw.
Interface: SSCNET type.
Voltage: single phase AC200V.
MR-J2 series server system has the ability to carry out a higher precision control,
Using high performance CPU, greatly improve the responsiveness of the product,
Speed loop frequency response increased to 550HZ MR-J40MA.
Various series of servo motors are suitable for different control requirements,
The encoder on the servo motor supports ABS mode,
As long as the servo amplifier on the other plus batteries,
Can form an absolute position system MITSUBISHI MR-J40MA.
Type: MR-J series.
Rated output: 0.4KW.
Suitable for motor series: HA-ME.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control MITSUBISHI MR-J40MA.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robot control of the indexing table MITSUBISHI MR-J40MA.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor.
Encoder serial communication system, the communication frequency can only be limited to 10M. MR-J2M multi axis servo amplifier substrate.
Groove position: 4.
The comparison is to compare the input command signal with the feedback signal of the system in order to obtain the deviation signal between the output and the input,
Usually implementeed by a dedicated circuit or computer MR-J40MA.
The controller is usually a computer or PID control circuit, and its main task is to transform the deviation signal from the output of the comparator,
To control the execution of components as required.