Product name: N@@-type CPU Units with 30 I/O Points.
Specifications: Power Supply, 100 to 240 VAC; Inputs, 8; Outputs, 6;
Output type: Transistor (sourcing).
Program capacity: 8K steps.
memory Data capacity: 8K words.
External powersupply(24 VDC): --.
Current consumption: 5 V, 0 C200H-CPU21-E.22A; 24 V，0.02A.
Standards: UC1, N, L, CE.
TThe CP1E Programmable Controller: Economical, Easy to use, and Efficient.
The E@@(S)-type Basic CPU Units provide cost,
performance and easy application with only basic functionality C200H-CPU21-E.
The N@@(S@) and NA-types Application CPU Units,
support Programmable Terminal connection, position control,
and inverter connection. Output type: Relay.
Inputs points: 12 points.
Outputs points: 8 points.
C200H-CPU21-E CPUs
High Spec, Small Rack Style
The C200H-CPU21-E and C200H-CPU23-E controllers offer increased I/O capacity and the same basic functionality as the OEM versions C200H-CPU21-E. In addition,
these controllers offer an extended instruction set,
expansion. A variety of CPUs are available with various memory and I/O configurations allowing selection based on application requirements OMRON C200H-CPU21-E.C200H Accessory Interface Unit C200H-IP006Connects Power Supply Adapter and SYSMAC NET Link Unit.
Included with C200H-APS01.Name: Temperature Control Module.
Model: C200H-TC102.
Sensor: Platinum resistance thermometer: JPt100 Pt100 OMRON C200H-CPU21-E.
Control output: Voltage output.Name: I/O Interface Unit.
Specifications: Applicable systems,
Duplex CPU, Single I/O Expansion System,
or Single CPU System;
Duplexing, Not supported;
Online Replacement, Not supported;
Mounting Backplane,Expansion Backplane;
Connecting Cable,
Long-distance Connecting Cable OMRON C200H-CPU21-E.
Current consumption: 5V system, 0.23A;
26V system, --.
Standards: U, C, N, L, CE.
Redundant CPU Units , Power Supply Units ,
Communications Units ,
and Expansion I/O Cables. CV500-FH SYSMAC BUS PC Unit Floppy/Hard Disk Drive For 200 VAC CV500-FHD02.Unit type: CS1 CPU Bus Units.
Product Name: MECHATROLINK-II,
compatible Position Control Unit.
Specifications: Control commands,
executed by MECHATROLINK-II,
synchronous communications.
Direct operation by ladder,
programming, Control mode:
Position control, speed control,
or torque control; No. of axes: 4.
No. of unit numbers allocated: 1.
Current consumption: 5V, 0.36A; 26V, --.
Standards: UC1, CE.
Decrease TCO with Simple Operation,
Reduced Wiring, Batch Settings,
annd Batch Management C200H-CPU21-E.
Control Servos for up to 16 axes,
in a motion network with one Position,
Control Unit that supports MECHATROLINK-II.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.