Servo motor type SGMPH (speed: 3000r/min).
Power: 0.2kw.
Power supply voltage: single phase AC200V.
Serial encoder: 16 bit relative value.
Design sequence: A SGM7P-01AFAH701 PDF.
Shaft end: straight shaft without key.
Optional parts: with oil seal, DC24V brake.
Partial flat series: the need to install the servo motor in a small space.
Flexible user system.
For you to build the best system to enrich the product line to support you SGM7P-01AFAH701
Products with single phase 200V, single phase 100V, three-phase 200V,
And for the absolute value encoder, a variety of motor with brake, belt speed reducer.
And then, because of its compliance with international standards, in the world can be assured that the use of SGM7P-01AFAH701 PDF.
Smooth running, there is a very seasonal rate of observation and control,
The speed fluctuation of the motor is greatly reduced, and the speed of the motor can be smoothly operated.Direct drive type servo motor SGMCV type SGM7P-01AFAH701 PDF.
Rated torque: M \/ 17N.
Servo motor diameter: diameter of 135mm.
Serial encoder: 22 bit (single cycle absolute encoder).
Design sequence: A.
Flange: reverse load side.
Optional parts: do not buy pieces.
Under the condition of no speed reducer, the load is directly driven.
Can be realized from low speed to high speed of the strong smooth running
(instantaneous maximum torque: 12 ~ 75N \/ m, maximum speed: 500 ~ 600r\/min) Yaskawa HARDWARE MANUAL.
By using 22 bit high resolution encoder, the high precision can be carried out. SGM7P-01AFAH701 Manual.
The use of hollow structure, convenient wiring and piping.
Use example:
Semiconductor manufacturing apparatus Yaskawa HARDWARE MANUAL.
Liquid crystal circuit board manufacturing device.
Various inspection and test equipment.
Electronic component packaging machine.
C information processor.
C inspection equipment.
A variety of automated machinery.
ManipulatorDC power input servo unit type SGDV Yaskawa HARDWARE MANUAL.
Maximum applicable motor capacity: 11W.
Power supply voltage: DC48V.
Interface: MECHATROLINK- II communication command type (rotary servo motor).
Design sequence: B.
Realize real time communication.
The maximum transmission speed is 10Mbps, the communication cycle of 250 tested s ~ 4ms (depending on the device),
Can carry up to 30 stations of the high speed control. Through the high speed of communication, can send and receive all kinds of control information in real time.
Energy saving and high efficiency
A maximum of 30 stations can be connected to the communication lines, can significantly reduce the wiring costs and time.
The command connector of the upper controller only needs 1,
Pulse geenerator for D/A converter or position instruction without speed / torque command SGM7P-01AFAH701 HARDWARE MANUAL.
High precision motion control is realized.
In addition to torque, position and speed control, but also to achieve high precision synchronizatioon phase control SGM7P-01AFAH701 Manual.
Because the control mode can be switched on line, the complicated mechanical efficiency can be realized more effectively and smoothly.