A connector that connects the DIO interface for connecting an external I/O device (5 sets).Suitable for GLC2300 series2GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA8-ODP10-01 PDF. 13 pin input connectors for HTB and 16 pin output connectors. (1 / set)The main controller is connected to the man-machine interface for MPI communicationThe main controller is connected to the man-machine interface for MPI communicationGP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelUSB cable to prevent disconnection of the fasstening clip (5 / set)COM2 terminal adapter for communication through the RS-422/485 connection1GB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA8-ODP10-01 PDF CA8-ODP10-01 Manual CA8-ODP10-01 Expansion module for the GP3000 access to the DeviceNet network and communication with the DeviceNet master station128MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card CA8-ODP10-01 PDF. For 5.7 inch models, prevent cable loose from the USB cable fastening clip (5 / set) Proface User's Manual. Protection for GP rear connectors (large and small for each of the 1).COM1 interface with the cable for direct connection to the CPU series PLC AConnect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM25.7 inches, for the protection of the man-machine interface from oil and chemical pollution (5 / set) Proface User's Manual. 512MB, for the implementation of the picture save, log and data backup and other data manageement operations, such as compression flash memory card CA8-ODP10-01 User's Manual. 12.1 inches /10.4 inches (STN), the GP installed to the hard panel to provide dust and moisture proof function Proface User's Manual. Expansion module for the GP3000 access to the CANopen networrk and communication with the CANopen master stationCOM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connection