COM2 adapter for converting the COM2 interface to the RS-422 terminal blockCOM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interfaceCOM1 interface with the cable (RS-232C), used to connect directly to the SYSMAC connection module (or other host)For 5 CA6-USB232-01 PDF. 7 inch models, for fixing the hooks of the three EX modules.Extended cable for connecting USB (Type-A) (LT) interface CA6-USB232-01Slave station module for connecting support for CANopenCOM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connectionGP-230/250/270 series is replaced by ST series, the gap filled with thhe opening of the panel10 CA6-USB232-01 PDF CA6-USB232-01 Manual. 4 inches (TFT), the replacement of the host backlight (1).Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2Disposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceFor 5 CA6-USB232-01 PDF. 7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.The main controller is connected to the man-machine interface for MPI communication13 pin input connectors for HTB and 16 pin output connectors. (1 / set)Extension cable for connecting USB (Type-A) interface to front panel Proface User's Manual. For 5.7 inch models, connect the connector to the DIO interface. For connecting external I/O devices. (5 / set)Suitable for GLC2300 series256MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card Proface User's Manual. Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communication10.4 inches and above, used to connectt the power cord (5 / set) CA6-USB232-01 User's Manual. 10.4 inches (TFT), the replacement of the host backlight (1).15 inches, replaced by a host of backlight (1) Proface User's Manual. 7.5 inches /3.8 inches /5.7 inches, used to connect the power cord (5 / sets) CA6-USB232-01 Manual. COM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)