Refer to Safety Precautions for All Power Controllers.
Used in Combination with the G3PA to.
Enable High-precision Temperature Contro.
Use cycle control to achieve power control with little noise GX-ID1628 PDF.
Used in combination with the G3PA to connect to single- and,
three-phase loads.
Three types of input method available: Internal adjuster,
external adjuster, or DC signals from 4 to 20 mA GX-ID1628
Streamline design. Both DIN track mounting and screw,
mounting possible.
Use linking terminals for close mounting of the G3PA.
Built-in isolation transformer.
Power supply range: 100 to 240 V. Terminal (wire connection): Push-In Plus Terminal GX-ID1628 PDF.
Applicable output load: AC load.
Zero cross function: No.
Rated input voltage: AC 230V.
Global standard size,
low profile slim I/O relay with width 6.2 mm,
slim I/O solid state relay.
Realized about 25% lower profile than conventional,
products, contributing to further miniaturization of the,
control panel GX-ID1628 PDF.
Push-In Plus terminal bloocks are used to save wiring work,
in comparison with conventional screw terminals GX-ID1628 Manual.
(Wiring time is reduced by 60%* in comparison with,
traditional screw terminals.).
No screw loosening means maintenance-free application,
realizing high reliability OMRON PROGRAMMING MANUAL.
Hand-free structure that holds an inserted flat-blade,
screwdriver to achieve easier wiring work for stranded wires.
Screw terminal is also stocked to meet the screw type needs.
Mounted relay or solid-state relay has a plug-in terminal.
that is difficult to bend at the time of exchange OMRON PROGRAMMING MANUAL. Internal I/O common: NPN.
I/O indicators: LED display (yellow). 140 mA max.
(for 20.4 to 26.4-VDC power supply voltage)
e-CON Connector insertion durability: 50 times.
Weight: 220 g max.
Expansion functions: No.
Short-circuit protection function: Available at input,
section only (Operates at 50 mA/point min OMRON PROGRAMMING MANUAL. )
Easy wiring using industry standard,
e-CON connectors.
Special wiring tool is not necessary.
Digital I/O terminal with industry,
standard e-CON connectors.
A common terminnal is provided for,
each connector GX-ID1628 PROGRAMMING MANUAL.
The I/O terminal and the sensors can,
be connected directly.
Input response time can be switched for,
high-speed processing.
Selectable node address setting methods:
setting with rotary,
sswitch and with tool software GX-ID1628 Manual.
When setting the nodes with rotary switch,
setting is easy and node identification,
becomes possible for maintenance.