Cable /G79-Y_C with loose wire connecting terminal.
L size: 1000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable G3ZA-8A203-FLK-UTU PDF. Category: relay output.
Points: 16 points (1a * 16).
Public connector side treatment: NPN (corresponding to the source of public).
Rated voltage: DC24V.
Pay attention to the use of convenience and space saving,
Relay terminal for 16 point output G3ZA-8A203-FLK-UTU
The terminal block is a long and thin type with a width of 135 * Deep 40mm.
It can be easily connected to the common end with the independent contact and short circuit chip G3ZA-8A203-FLK-UTU PDF.
Terminal units for power supply wiring processing can be extended.
M3.5 can be used with the Y fork type of the compression terminal (terminal width 6.2mm).
Can not use the tool to remove the relaay G3ZA-8A203-FLK-UTU Manual. Relay replacement operation is simple.
Equipped with relay type and power FET MOS relay mounted type G3ZA-8A203-FLK-UTU PDF.
With action indication LED.
DIN guide rail installation, screw mounting common. Unit: Connector model.
I/O classification: Digital output.
Internal I/O common: NPN (- common).
I/O points: 16.
I/O connections: Fujitsu connector.
Power supplyvoltage: 24 VDC OMRON REFERENCE MANUAL.
I/O specification: 0.5 A, DC/transistor.
Digital I/O Units Compatible with MULTIPLE I/O TERMINAL,
Terminal block, connector, and high-density connector,
models are available.
The circuit block of the terminal block model can be,
mounted or dismounted for ease of maintenance without,
disconnecting the wires OMRON REFERENCE MANUAL.
DIN track mounting. Isolation: Photo-voltage coupler.
Zero cross function: No.
Indicator: Yes.
Rated output load: 0.5 A at 24 to 240 VAC, 0.5 A at 24 to 110 VDC.
Rated input voltage: 24 VDC.
100-A-max. Leakage Current, No Bleeder.
Resistor Required.
1 mA to 500 mA micro-load switching OMRON REFERENCE MANUAL.
Switch to both AC and DC with no polarity.
Switch ffor a wide range of voltages; 19 G3ZA-8A203-FLK-UTU REFERENCE MANUAL. 2 to 264 VAC, 19.2 to 125 VDC.
Switch full- and half-wave rectifier AC loads.
Same sizes and terminal arrangements as OMRON Power,
Relay MY Series.
Operating indicator provided.
Switch MY Series (without bleeder resistor) G3ZA-8A203-FLK-UTU Manual.
Superior surge absorption with a built-in varistor.
Optimum SSR to control minute load, valves, and solenoids.