Size: 96 x 96mm.
Type: power AC/DC24V with.
Shell color: black.
Control output 1: position ratio with relay output.
Control output 2: position ratio with relay output E5CN-QMT-500 PDF.
Control mode: position ratio control.
Auxiliary output points: 2 points.
Event entry point: 4.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: -.
General thermostat new high performance (high resolution, high speed, high precision input) type products E5CN-QMT-500
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved E5CN-QMT-500 PDF.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP E5CN-QMT-500 PDF.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output OMRON USER'S MANUAL.
Increase thhe control output ON/OFF number counting function, can predict the temperature controller internal relay fault E5CN-QMT-500 Manual.
Position ratio type. Small amplifier built-in type photoelectric switch
The body is thin and long, saving space, the volume is only 50 * 50 * 17.4mm
M.S.R function can detect smooth, shiny objects
New photoelectric -IC, enhance anti interference
Power reverse connect, output short circuit and output reverse protection (AC model no)Size: M12 (Brass); Single; Shielded OMRON USER'S MANUAL.
Sensing distance: 5 mm.
Connecting method (See note 1.): M12 Connector.
Body length: Long OMRON USER'S MANUAL.
Output configuration: PNP.
Operation mode NC.
A new generation in global applications. Power supply voltage: DC.
Sensing method: Through-beam (Emitter + Receiver).
Sensing distance: 5 m.
Output configu ration: NPN.
Long-distance Photoelectric Sensor.
That Supports AC/DC Power Supplies.
Long sensing distance that is approximately 8,
times that of our conventional model (for the,
Through-beam and Diffuse-reflective models).
(Through-beam: 40 m, Retro-reflective: 7 m, and,
Diffuse-reflectiive: 2 E5CN-QMT-500 USER'S MANUAL. 5 m.) .
Improved visibility:
A red LED that makes the spot visible.
Large indicators that can be seen even from a,
distance.
Improved operability.
(Enlarged sensitivity adjuster and operation selector)
Freely selectaable power supply input (24 to 240 VDC, 24 to 240 VAC) E5CN-QMT-500 Manual.
(Additional types added to the DC type lineup.)
Models with infrared LEDs are also available.