Model: Shielded, M18.
Sensing distance: 5 mm.
Output configuration: DC 3-wire, NPN.
Model: Operation mode, NO.
Proximity Sensor with Resin Case,
with Superb Water Resistance E5CN-HTV2MD-500 PDF.
IP68 protection.
Mutual interference prevention with models with different,
frequencies is also available. Slit width: 1-mm dia.
Installation procedure: Plug-in type.
Applicable type: E3T-ST@M. Name: Reflectors E5CN-HTV2MD-500
Directional angle: 30° min. *2.
Ambient operating temperature range: -25 to 55°C.
Ambient storage temperature range: -40 to 70°C.
Ambient operating humidity range: 35% to 85%.
Ambient storage humidity range: 35% to 95% E5CN-HTV2MD-500 PDF.
Degree of protection: IEC IP67.
Accessories: --.Size: 48 x 96mm.
Category: power AC100 ~~ 240V with E5CN-HTV2MD-500 Manual.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater E5CN-HTV2MD-500 PDF.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: RS-485.
General thermostat new high performance (high resolution, high speed, high precision input) type products OMRON User's Manual.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved.
High resolution 5 bit display / can display 0 OMRON User's Manual. 01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostaat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV OMRON User's Manual E5CN-HTV2MD-500 User's Manual.
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output E5CN-HTV2MD-500 Manual.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type.