Three-phase Phase-sequence Phase-loss.
Relay Using Voltage Detection Method.
Greater resistance to inverter noise.
Distinguishes between correct phases, phase sequence, and phase,
loss when power is turned ON.
Supports phase loss detection when the motor is operating.
5 A (resistive load) at 250 VAC, DPDT x 1 K3HB-VLC-E1 AC/DC24 PDF.
Output status can be monitored using LED indicator.
Ideal to prevent reverse operation of motors K3HB-VLC-E1 AC/DC24 Input type: NPN/ voltage pulse input type.
Event input terminal 5 points (HOLD, RESET) equipped with.
External power supply DC12V80mA.
Note: K3HB-RPB-A, K3HB-RNB-A is not equipped with event input.
Relay contact: HH; PASS1c, H, L, LL: each 1a.
96 (W) * 48 (H * 95mm) depth.
Power supply voltage: AC100 ~ 240V K3HB-VLC-E1 AC/DC24 PDF.
Measurement of 2 points through the speed, time, or cycle of the digital time interval table.
Action determine the color, can switch the green / Red 2 kinds of color display.
Measurement of wide range of pulse interval time.
Measuring, calculating and displaying the pulse interval between 2 points.
Pulse interval measurement range, the maximum can be measured from 10Rated input voltage: 3-phase 3-wire mode, 200, 220, 230, or 240 VAC K3HB-VLC-E1 AC/DC24 PDF.
Ideal for Monitoring 3-phase Power Supplies.
for Industrial Facilities and Equipment.
Greater resistance to inverter noise.
Monitor undervoltages, phase sequence, and phase loss in three,
phase three-wire circuits with one unit.
One SPDT output relay, 5 A at 250 VAC (resistive load).
World-wide power specifications supported by one unit.
(Set with a rotary switch.).
Relay status can be monitored using LED indicator. Measure High-speed Up/down Pulses with this.
Up/down Pulse Meter.
Visual conf0rmation of judgement results through display colors that,
switch between red and green.
Perfect for Measuring Rotary Encoder and ON/OFF Pulse Signals at High Speed,
Cumulative pulse innput is 50 kHz, quadrature pulse inputs are 25 kHz,
and up/down pulse inputs are 30 kHz K3HB-VLC-E1 AC/DC24 datasheet.
Note: No-voltage contacts of up to 30 Hz are supported.
The count value can be converted to any value.
The length equivalent ffor any pulse can be set to any desired value K3HB-VLC-E1 AC/DC24 datasheet. This is,
effective for feed amount and position monitor displays.
DeviceNet models added to the series.