Cable /G79-Y_C with loose wire connecting terminal.
L size: 5000mm.
Cable and loose wire cable with loose wire pressing connecting terminal,
Connector cable, MITSUBISHI motor produced PLC connection cable. Structure: single stable type.
Contact structure: 1a.
Structure: high flux protection.
Coil rated voltage: DC24V G3PE-245B-3N DC12-24 PDF.
Voltage resistant 10kV 1 pole 3A open close small relay G3PE-245B-3N DC12-24
High power electromagnetic loop is used to achieve high sensitivity (200mW).
Small relays, but can ensure the impact resistance of 10kV. Type: Standard.
Latching lever (Test switch): NO.
Rated input voltage: DC, 11.
Applicable model: G2RV-SR700/500 DC12V.
Global standard size, low profile slim.
I/O relay with width 6 G3PE-245B-3N DC12-24 PDF. 2 mm.
Realized about 25% lower profile than conventional.
products, contributing to further miniaturization of the control panel.
Realized opening and closing ability with one pole 6 A slim shape.
Micro load products for one pole 50 mA using Au-plated.
contacts for small load switching also available.
Since G2RV is a transparent case, confirming the state of,
the contact with the naked eye is possible, and easy to,
confirm abnormality on-site (installed location) G3PE-245B-3N DC12-24 PDF.
Screw terminal is also stocked to meet the screw type needs.
Mounted relay uses plug-in terminals that are difficult to,
bend when exchanging. Name: System Units; I/O Power Feed Unit.
Specifications: Use to add V/G terminals,
for I/O power supply.
Standards: CE, UC, L.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Name: Multi-channel Power Controller.
Number of control channels: 4.
Heater burnout detection: Not supported.
Load power supply voltage: 400 to 480 VAC.
Optimum Cycle Control for High-precision.
Control with Low Noise.
Smaller than a Normal Power Controller.
Enables low-noise power control in combination with zero-cross.
SSRs. (See note.).
One Controller can control up to 8 SSRs.
RS-485 communications to set manipulated variables and,
heater burnout detection. The Smart FB Librarry for the G3ZA,
can also be used G3PE-245B-3N DC12-24 datasheet.
CE Marking.
Main Upgraded Functions.
Soft-start function added for lamp heaters.
Three-phase optimum cycle control added for three-phase heaters.
Combining with special CT for1550-A current detection G3PE-245B-3N DC12-24 datasheet.
Note: The G3ZA must be used in combination with an SSR without the,
zero cross function when the soft-start function is used.