Unit classification: CJ1 CPU Bus Units.
Product name: Motion Control Unit with,
MECHA TROLINK-II interface.
Specifications: Control modes : Position,
speed, or torque control via MECHATROLINK-II,
Control axes : 32 axes max. (30 physical axes,
2 virtua axes).
Internal programming language: Special motion contro
language
No CP1E-E14DR-A PDF. of unit numbers allocated: 1.
Current consumption: 5V, 0 CP1E-E14DR-A60A; 24V, --.
Standards: UC1, CE.
Improve Equipment Design Efficiency,
and Shorten Tact Time.
Control Servos for up to 16 axes in,
a motion network with one Position,
Control Unit that supports MECHATROLINK-II.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association. Unit type: CJ1 Basic I/O Units CP1E-E14DR-A PDF.
Product name: Transistor Output Units.
Specifications: Output type, Sinking;
I/O points, 64 outputs;
Maximum switching capacity, 24VDC, 0.3A;
Commons, 16 points, 1 common;
External connection, MIL connector.
No. of words allocated: 4 words.
Current consumption: 5V, 0.17A; 24V, --.
Standards: UC1, N, L, CE.
A Wide Range of Basic Output,
Units for High Speed Output,
and Different Applications CP1E-E14DR-A PDF.
These Output Units receive the ,
results of output instructions ,
from the CPU Unit and perform ON/OFF,
control for external devices.
High-speed Output models CJ1W-OD213 and,
CJ1W-OD234 can help to increase system.
throughput. Connector 24 PIN Crimp Type C500-CE242Model: Unit version 1.2.
NJ system: CPU Rack;Expansion Rack,
Not supported.
CJ1 system: CJ1 system, Expansion Backplane,
8 Units (per CPU Unit).
CP1H system: CP1H PLC, 2 Units.
NSJ system: Controller NSJ, Not supported;
Expansion Backplane, 8 Units.
New Controller Link Units,
Now with 4,000 Send Words.
The Controller Link is an FA,
network that can send and receive,
large amounnts of data easily,
and at high speed CP1E-E14DR-A datasheet.
The Controller Link supports data,
links that enable sharing,
data between PLCs and computers,
and a message service that enables,
sending and receiving data whenever required.
Systtems can be flexibly built by using Repeater,
Units to enable T-branches, long-distance wiring,
and converting part of the network to optical cable CP1E-E14DR-A datasheet.