MITSUBISHI universal AC servo amplifier MELSERVO-JE series.
Rated output: 0.75kw.
Interface: SSCNETIII/H.
Compatible motor: HG-KN73J-S100, HG-KN73BJ-S100.
Superior basic performance and advanced ease of use, to promote the process of equipment servo.
MR-JE-B support servo network.
Advanced performance and ease of use MR-J3-10B-RJ080W PDF.
In order to allow you to build advanced drive control system,
MITSUBISHI motor will provide you with a full range of servo amplifier, servo motor, programmable controller, positioning module, display, and even advanced solutions MR-J3-10B-RJ080W
In the global support system, including the purchase of products to the after-sales service, the performance of MELSERVO-JE will play to the extreme in the world MR-J3-10B-RJ080W PDF.
Support servo system network SSCNETIII/H.
Can achieve the system of high response speed, multi axis, the performance of the synchronization, the line of the line.
In addition, the encoder can be used as an absolute position encoder in a servo motor.
The absolute position detection system.
At the same time, the high performance of the equipment can be realized by the simple movement module, such as the mark detection, the electronic cam, the advanced synchronization control function and so on MR-J3-10B-RJ080W PDF. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 7.0kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC400V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operatiions MR-J3-10B-RJ080W datasheet.
Serial communication reduce wiring.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J3-10B-RJ080W datasheet.
When the two stations are occupied, the speed can be set directly by the remote register.