Memory format: EEPROM.
Number of steps: up to 2000 steps can be used.
Battery support: do not.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device.
Note: the built-in program transfer function (FX1S and FX1N host generic). Can be isolated to obtain DC24/48/100V, AC100/200V input signal FX-232CAB-1 PDF. Needle number: 40.
Specification: loose wire connector, 5 sets (0 FX-232CAB-13mm 2). Cable length: 0.5m.
RS-485 terminal unit conversion unit.
Applicable model: GT16. Output: 16 points.
Function: transistor output models (source type).
Corresponding models: FX3GA, FX3G, FX3GE, FX3GC, FX3U, FX3UC.
Can carry on the FX3GC, the FX3UC basic unit and the expansion module or the localization module the connector and the terminal station transformation,
Save the time of the input and output connection, realize the labor saving FX-232CAB-1 PDF.
The use of built-in input and output components models,
Can receive AC100V input, or through the relay or the transistor to drive large capacity load. Analog input points: 4.
Analog output points: 1 points.
Analog input and output expansion module FX-232CAB-1 PDF.
With 4CH analog input and 1CH analog output.
With -100mV~100mV micro voltage input range, and therefore do not need a signal converter, etc..
Resolution of 15 bit binary + symbol 14bit, 1bit binary + symbol 1bit high precision analog input and output modules.
Each channel can be used for different input ranges.
Built in input filter adjustment function, internal operation function, proportion function.
Connect FX3UC, FX3GC, you need to use FX2NC-CNV-IF or FX3UC-1PS-5V. Power: 15kw.
Voltage: 400V.
There are 100% braking torque output in conttinuous regeneration, which can correspond to the continuous regeneration operation of the pipeline control FX-232CAB-1 datasheet.
There is no need to install the braking unit for each frequency converter, which can reduce the comprehensive space annd reduce the comprehensive cost FX-232CAB-1 datasheet.
Renewable energy can be used for other frequency converter, excess energy back to the grid, to achieve energy saving.