Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FR-A720-90K PDF.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FR-A720-90K
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FR-A720-90K PDF.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Specifications: FX0N-65EC.
Cable extending unit.
Length 65CM. Analog input points: 4.
Analog output points: 1 points.
Analog input and output expansion module.
With 4CH analog input and 1CH analog output.
With -100mV~100mV micro voltage input range, and therefore do not need a signal converter, etc FR-A720-90K PDF. .
Resolution of 15 bit binary + symbol 14bit, 1bit binary + symbol 1bit high precision analog input and output modules.
Each channel can be used for different input ranges.
Built in input filter adjustment function, internal operation function, proportion function.
Connect FX3UC, FX3GC, you need to use FX2NC-CNV-IF or FX3UC-1PS-5V. Total input and output points: 8 points.
Output points: 8 points.
Output type: transistor output.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit.
FX Series in the compact body built in superior performance, and strive to operatee simple FR-A720-90K datasheet.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can bbe extended to all models in the FX series analog devices FR-A720-90K datasheet.
Function extension board, special adapter without programming can be used for communication.